Primary Non-Metallic Surface Hardener
Primary non-metallic surface hardener Product introduction:
The main non-metallic floor Curing Agent is a new type of industrial floor. It uses metal, non-metallic and other wear-resistant aggregates combined with a variety of additional hardener components, and solidified with the newly cast concrete layer to form a dense, wear-resistant, impact-resistant smooth surface. Widely used in heavy machinery workshops, dust-proof, wear-proof and moisture-proof workplaces.
High Wear Emery Ground Scope of application:
The scope of application applies to places where impact resistance and dust reduction are required, such as: warehouses, docks, factories, parking lots, maintenance workshops, garages, warehouses, etc.Epoxy Flat Ground And Mortar Floor,Flat Painted Epoxy Floor.
Wear Hardened Ground Performance characteristics:
1, Impact resistance, heavy pressure, good mechanical properties;
2, dust, mildew, wear-resistant, good hardness;
3, Heavy pressure resistance, strong wear resistance, no dust, enhanced resistance to ground oil, anti-infiltration;
4, bright appearance, rich and varied colors;
5, easy to clean, easy to maintain.
Synchronize with concrete ground,Light Grey Epoxy Flat Coating.
High Wear Non-metal Emery basic requirements:
The concrete strength of the grass-roots level should be above C25, the water-cement ratio should be controlled below 0.50, and the difference in concrete shedding should be controlled within 70-100mm. The concrete mixture should minimize segregation and control the leakage; in order to ensure the full fluidity of the concrete mixture And construction is conducive to construction, it is recommended to add appropriate additives in the concrete. The concrete of the grass-roots level should be poured and compacted according to the standard of concrete fineness, pay attention to the size and reduce the production of laitance. The hardener surface is constructed simultaneously with the concrete structure layer. If the same leveling layer is constructed at the same time, it is recommended that the leveling concrete should be fine stone concrete with a thickness not less than 50mm. Consider deploying a retractable reinforcement mesh, paying special attention to the corners of the concrete structure block. Ensure that the concrete in the area vibrates and compacts and take additional reinforcement measures.Self-Leveling Epoxy Floor Paint,Epoxy Antistatic Self-leveling Floor.
Non-Metallic Ground Hardener construction process:
Surface treatment: Use a mechanical rake with a disc to evenly remove the laitance layer on the concrete surface; first spread out the diamond wear-resistant floor material: spread a prescribed amount of 2/3 hardened wear-resistant floor material evenly on the surface. After the initial solidification stage of the concrete surface, polishing with a low speed scraper;
Scratch ruler: Use a 6m spatula to evenly clean the rough level of the corundum wear-resistant flooring material; apply the material a second time: Apply a uniform amount of 1/3 of the color diamond abrasive material to the abrasion resistant floor material. (After passing through the surface of the first grindstone wear-resistant floor material), it is then polished again with a t knife; surface polishing: According to the hardening of the concrete, the angle of the blade on the polishing machine is adjusted, and the surface polishing operation is performed to ensure the surface Flatness. Smooth and clean; Base surface swelling: During the 4-6 hours after the construction is completed, the diamond abrasion resistant floor should be maintained on the surface to prevent rapid evaporation of surface moisture and to ensure a steady increase in the strength of the wear-resistant diamond floor.
Looking for ideal Non Metallic Material Manufacturer & supplier ? We have a wide selection at great prices to help you get creative. All the Non Metallic Magnetic Material are quality guaranteed. We are China Origin Factory of Non Metallic Structural Materials. If you have any question, please feel free to contact us.
Product Categories : Floor Coating Series > Non-metallic Ground Hardener