Yellow metal ground hardener Product Overview: Yellow Metal Wear-resisting Floor is suitable for industrial plants, production workshops, warehouses, logistics centers, garages, parking lots, supermarkets and other places and other places require the ground can not afford dust, and can withstand the rolling of various vehicles (such as cars, forklifts, carts, etc.) The grounds of special places such as supermarkets, buildings, warehouses, auto showrooms, auto repair shops, and underground parking lots; areas with high mechanical performance requirements, mechanical, electronic, electrical appliances, instruments, medicine, textiles, clothing, etc. The floor of a factory building for food and tobacco. Therefore, the floor of these places must not only have the flat and smooth decorative effect of the general floor protection system, but also have strong wear resistance and pressure resistance. Therefore, the corundum wear-resistant floor is a floor system that professionally solves the ground protection problems of heavy machinery manufacturing plants, industrial and commercial warehouses, underground parking lots and other ground protection issues.
The Yellow Metal Floor is Wear-resistant Product Features: Impact resistance, heavy pressure resistance, good mechanical properties; Dustproof, mildewproof, wear resistant, good hardness; Heavy pressure resistance, strong abrasion resistance, no dust, enhanced ground oil resistance, resistance to penetration; The appearance is smooth, bright and diverse; Easy to clean and easy to maintain.
Yellow Metal Floor Material Basic requirements: The concrete strength of the grass-roots level shall be above C25, the water-cement ratio shall be controlled below 0.50, the difference between the concrete fall-out shall be controlled within 70-100mm, and the concrete mixture shall minimize segregation and control of bleeding; in order to ensure adequate flow of the concrete mixture Sex and construction are conducive to construction, it is recommended that concrete be added with proper additives. Grass-roots concrete should be poured and tamped with reference to the standard of fine concrete, pay attention to the size and reduce laitance production. The hardener surface is constructed simultaneously with the concrete structure layer. If the same leveling layer is to be applied at the same time, it is recommended that the leveling concrete should be fine stone concrete with a thickness of not less than 50mm. Consider configuring the telescopic reinforcement mesh with special attention to the corners of the concrete construction block. Ensure that the concrete in the area is vibrated and compacted and additional strengthening measures should be taken.
Metal Floor Hardener Construction process: Surface treatment: Use a machine equipped with a disc to evenly remove the laitance layer on the concrete surface; first spread the silicon carbide wear-resistant floor material: spread the prescribed amount of 2/3 hardened wear-resistant flooring material evenly. After the concrete surface of the initial coagulation stage, it is polished with a low-speed screeding machine;
Scratch ruler leveling: Use a 6m scraper to evenly and horizontally erase and rough level the corundum wear-resistant flooring material; second time spread the material: uniformly spread the prescribed amount of 1/3 color diamond abrasive wear-resistant flooring material. (After the surface of the first ground diamond abrasive wear-resistant floor material), it is polished again with a trowel; surface polishing: According to the hardening of the concrete, the angle of the blade on the polishing machine is adjusted, and the surface polishing operation is performed to ensure the surface flatness. Smooth finish; base surface expansion: Emery wear-resistant floor should be maintained on the surface within 4 to 6 hours after the completion of the construction to prevent the rapid evaporation of surface moisture and ensure a steady increase in the strength of the diamond abrasion resistant floor.
Looking for ideal Yellow Metal Wear-resisting Floor Manufacturer & supplier ? We have a wide selection at great prices to help you get creative. All the The Yellow Metal Floor is Wear-resistant are quality guaranteed. We are China Origin Factory of Yellow Metal Floor Material. If you have any question, please feel free to contact us.
Product Categories : Floor Coating Series > Metal Floor Hardener