Jiangmen Kasole Building Materials Co., LTD.
Epoxy Self Leveling Sand,Epoxy Color Sand Floor Coating,Epoxy Sand Self-Leveling Paint,Grass Green Epoxy Self-Leveling Sand
Epoxy Self Leveling Sand (Self-Leveling) / Self-leveling epoxy sand (floating sand self-leveling)
Epoxy self-leveling sand is an environmentally friendly material, low odor, solvent-free, wear-resistant, self-leveling decorative coating of epoxy sand floor, which consists of a special effect of flowing sand aggregate and polymer resin composition, with Rich colors, excellent weatherability, wear resistance, compression, chemical resistance and excellent anti-skid performance, stable and reliable performance, decorative appearance.
1, excellent impact resistance;
2, excellent wear resistance, wear ≤ 20mg (750g / 500r);
3, good skid resistance, friction coefficient ≥ 0.60;
4, excellent acid and alkali resistance;
5, a good decorative effect
6, construction is simple;
Scope of adaptation:
Schools, hospitals, offices, offices, exhibition rooms, exhibition halls, kitchens, stores, laboratories, restaurants, pharmaceuticals, tobacco industry and so on.
Base surface temperature: 10 ℃ ~ 30 ℃;
Basis moisture content: <4%;
Ambient temperature: 10 ℃ ~ 30 ℃;
And higher than the dew point temperature above 3 ℃;
Relative humidity: ≤ 80%;
1, the base surface treatment: grinding, cleaning the surface of floating pulp, dust cleaning surface oil, repair holes, cracks
2, epoxy primer: infiltration to the base surface, increase the strength of the base surface and increase the adhesion of the base layer with the surface of the capillary closure of the capillary gap, to avoid the coating material further down infiltration, thus affecting the coating effect
3, epoxy coating: to improve the strength of the entire system to improve the defects of the base surface, such as potholes, small cracks to improve the flatness of the base coating mortar layer and putty layer, according to the needs of the ground design and selection
4, self-leveling Caisha surface coating
5, super wear-resistant surface coating (for selection)
3-5mm toothed trowel, defoaming drum, spikes, mixer and mixing sticks
Regional protection (for a variety of colors) --- Clean --- stirring material --- cleaning protective tape --- defoaming
1, the material should be mixed evenly, at the same time in the course of the need to re-expected, the barrel material mixing can be construction;
2, to use the same thickness trowel, the construction of a large area when the construction of a certain amount of area to check the trowel depth, such as tooth wear must be replaced trowel;
3, remember that since the construction of self-leveling sand must wear spikes defoaming, first with the trowel master defoaming, separated by a period of time to the construction area defoaming;
4, a variety of colors of construction, we must have done a good job of color protection, and at the same time in the construction of the region, within five minutes to protect the material clean, so as not to protect the material stick to the ground;
5, the amount of material can not be less than 2.5KG / ㎡;
6, since the construction of self-leveling sand painted layer before leveling to be closed, can not have holes.